The F/A-18 is a mid-mounted pusher model intended to be flown with tailerons only, but it can easily be equipped with ailerons and rudders.The dimensions of the slots and tabs are made for 6 mm depron.
- Laser cut pre-cut depron panels (Without any painting)
- The necessary 5mm pre-cut carbon fiber rods for your kit
- Control horns necessary for your kit
- Push rods necessary for your kit
- All necessary ply parts (laser cut)
- 10mm hardwood motor mount
F/A-18 Hornet is a twin-engine supersonic, all-weather carrier-capable multirole fighter jet, designed to dogfight and attack ground targets (F/A designation for Fighter/Attack). Designed by McDonnell Douglas and Northrop, the F/A-18 was derived from the latter's YF-17 in the 1970s for use by the United States Navy and Marine Corp.
THE IMAGES SHOWN ARE NOT THE PRODUCT WHAT WE SUPPLY. WE ONLY SUPPLY LASER CUT FOAM PANELS (SEE KIT CONTENTS) FOR BUILDING THE MODELS BY YOURSELF.
These pictures and videos shown in the product pages are of the finished products by the hobbiysts. Many of these hobbyists have been building longer than you have been alive. We do not guarantee that the finished product will look and perform same alike shown in our product pages. It depends upon your skill level commitment.
|Build Type||Quick Build|
|Material of Construction||Depron Foam|
|Length||102.5 cm (40.4 inches)|
|Wing Span||73.5 cm (28.9 inches)|
|COG Location||14.6 cm (5.75 inches) forward of the vertical stabilizers|
|Suggested Motor||2200 RPM/V|
|Suggested ESC||As per selected motor rating|
|Suggested Propeller||APC-E 6x4|
|Suggested Servos||2 x HS-55|
|Suggested Battery||3s 2200 mAh|